Enter your car's symptom:
CarBeast's AI makes sense of symptom descriptions and technician repair notes. It then uses that information to find cases similar to the one you're facing to provide a diagnosis.
Enter your car's symptom:
Enter the VIN or the make, model and model year of your car (e.g., 2012 Toyota Camry):
Here are some repair orders from CarBeast's database of hundreds of millions of repairs. Browse them or sign up and use Insight to get a full diagnosis.
What is a repair order?ENG AS PER 03.30.050027. ZS11 SOENOID UNITS-(ALL) VAR. VALVE TIME-CAM CONTROL MEHC, REPL.. ENGINE MINOR REPAIR CLIENT REPORTS GETTING CHECK ENGINE LIGTH ON PLEASE HCECK AND ADVISE
CEL ... GS10 BLANCE SHAFT REMOVE/INSTALL, INSPECT AND, IF NECESSARY, REPLACE (ENGINE REMOVED). CHECK ENGINE LIGH . IS NOT ON NOW. COMING ON AND GOES OF. RUN FOR OCDES.
665 *. GS10 REPLACED STICKIG COOLANT THERMOSTAT AND COOLANT - AND SERPENTINE BELT STRATING TO CRACK SO REPLACED WHEN IT WAS OFF. STATED CECK ENGINE LIGTH IS ON
HCECK EGINE LIGHT IS ON 0 PEFORMED SOHRT TEST. CURRENT CODE IN MULTIPLE CONTROL UNITS FOR OPEN CIRCUIT TO AMBIENT TEMPERATURE SENSOR. R&R FRONT GRILLE , EMOVED TEMP SENOR AND OHMS TESED SENSOR. SESOR OHM TESTED AT 2.7k OHM, OOD READING FOR CURRENT TEMPEATURE. R&R RIGHT FRONT WHEEL AND RIGHT FRT. INT FENDER LINER TO ACESS BMPER WIRING AHRNESS CONNECTOR. INSPECTED CONNECOR X26/32 AND IT LOOKS OK. OHM TESTED THROUGH BUMEPR CONNCTOR/AMBIENT TEMP SENSOR-SAME 2.7k OHM READING- BUMPERS SIDES OF HARNESS IS OK. BY PULLING GENTLY ON WIRING ON BODY SIDE FOUND LBACK WIRE IN PIN 10 PULLED OUT OF WIRE LOOMS EASILY. WIRING CONNECTION AT PIN 10 IS BROKE.N REMOVED PIN, INSTALLD NEW PIN ON BACK WIRE AT SLOT 10. ALL OCDES NOW STORED, AMBIENT TEMPERATURE IS NOW DISPLAYED IN A INSTURMENT CLUSTER. CLEARED ALL COES . TEMEPRATURE SENSOR WIRING REPIR
CHECK ENGINE LIGHT IS ON MACARE WARANTY $115/HR AUTH#13338368 TOTL COVERED-$305.40 $50 DEDUCT 2.5CP REPLACE LEFT EXHAUST CAM MAG.. CHECK ENGINE LIGHT